Tracktion 7 recording problem - garbled recording

[StewartM72]

I experienced a problem while recording in Tracktion 7 today that I cannot resolve. The audio becomes garbled for 8 seconds, clears up for roughly 30 seconds, and then repeats the cycle of 8 seconds garbled, 30 seconds clear as long as a signal is being input. This happens whether I am recording or not. I have uninstalled and reinstalled Both th 32 bit and 64 bit versions and I don't know what else to try. This only happens with T7. I checked other recording software on my computer and do not have a problem.

I have two audio clips I recorded. "Unidentified noise" is with my guitar and starts about 00:13. "Line recording, no guitar" is a ground loop from my amp to keep a constant signal. You can hear the cycle repeat several times.

https://clyp.it/user/gatvsxy4

Turn down your volume before playing the clips unless you are trying to wake up.

Thanks in adavance,

Stewart

[StewartM72]

I have been told by auto-admin I need to post 5 times before the link to the recording of the problem is unlocked...

[StewartM72]

So bear with me until...

[StewartM72]

I can post the required number of times...

[StewartM72]

To unlock the link. Thank you for your patience.

[StewartM72]

Stopping by to give everyone an update. Today, I uninstalled Tracktion, deep cleaned the registry, deleted any files or folders I created, and removed all the VST's with reboots of the computer in between. This has stopped the problem.

Now I am getting pops and clicks during recording. I saw another posyer with that problem, so I am going to uo check that thread out.

I'll post back in a week or so if I have any updates.

[terrynoakes]

Pops and clicks usually due to low buffer setting, and capabilities of computer.
In settings tab audio devices, try increasing the buffer size. I tend to use 512 samples.
But see what works best for you.