Hi Folks...so, I am using the Multi-Sampler in Waveform 9.1 to put together a drum track, it is doing a great job. But, there is one thing that was so easy with the old Sampler plug in (I know, I still have that one, too)... It had the "Ignore release" button, I always used that because some of the drum samples need to play out and a shorter MIDI note from the Step Clip cuts it off.
To use the new Sampler I had to convert the clip to MIDI and then lengthen the notes, easy enough but when using step clips the cut off sounds are a bit of a drag.
Is there a setting in the new Sampler for this that I am missing? I would not be surprised because I am quite new to using it and to sampling in general.
Multi-Sampler question
-
- KVRist
- 237 posts since 9 Dec, 2016 from Grand Rapids, Michigan USA
-
- KVRist
- Topic Starter
- 237 posts since 9 Dec, 2016 from Grand Rapids, Michigan USA
Ahh yes, the "one shot" thing is mentioned in the manual but I did not realize what it was. Thanks, I'll try it!