Automate point's smoothness in free mode on x rather than y axis?

[Annabanna]

It seems that the "smoothness" as an automatable parameter refers only to it's y-axis. This makes sense in some of the modes, but in free mode, it has 2 coordinates, and I specifically want to move it left to right.

If there is no "official" way to do this, does anyone know of a trick that would accomplish something similar? Trying at the moment to mimic that behavior by inserting and automating a point, but it's not quite doing what I want, so I thought I'd check to see if anyone has an alternate approach.

Below is MXXX instance with waveshaper smoothness automated via MP1... though it's moving on the wrong axis.

Code: Select all

$eNqVVFtv2jAUfu+vsLxXWpKUS5AIVYtgqtS0CLbCHr3kkFgzdmQ7DPrrd5wLA6o9jAfsfOc7t++cZPxw2AmyB224khH17zxKQCYq5TKLaGm3tyF9mNyM481mY8BahA35gkRKpkoIVhhIlzzL7YJJEBH1HC6tRhvGnEn2U0BawV+-P6-4BwToOwyHnXAYnLAZM0eH+6OgE-rIfVmuCsGtBe3MvjOFwTWMHsHonpKYHV7mb09CJb8cHNHwE-a23QouoSo7LoXlC6bZDjCQOXVRFbkCAYmFdCHKjKMeXgc93lt1sO5ef0An49ps2guZl0K8YsCIrtkeVjkrQBP0vMYo2VRpfrhKWu-Vpaz-2c6q1FqVMp3mTOIEGsmdYvUP07SUdyXKHXQn40yzIsf0iktLkipMcojorXfneaHX9-vBaDjyBgNK5oJl5gkZPeR8OxYYeK4BsLdu6-9vCjlUoY-uH+ndJm33su0TcLoYt2+XU5pcAZ5bnVnKrdKxSjHlq9I7JuqNQspS-a6EvjTW4zA7pWwuwRhUr4Bm8u9MlGj07sLRoHmqnRegE5DWuHm16auBL5nM0N6j5IR-3gFyS6ornrVcPklKvWe21EBJE8Lp7veHvdC793ujgf+3mkq3q9Y-IU6vx8TyPSw04EtKzh-qjVb6bM8xvpOu3sEps5ApfXy2sHuWW0UeS5srHVEkxYwLd3G4O9frNR5Y0hQ3CjVpBK2KPM-p6tEFdmfRGqAZ59mMcc1Tm8e4k6pEWQnyt1ygqfrc1O22lG7cNtc9--pMbv4AY4KCBg==

[Annabanna]

Dangit. Second time now I've hit quote instead of edit. Just trying to edit code to simplify above.

[MeldaProduction]

There is no vertical smoothness... what are you talking about???'
Aaaaaha... curvature... only Y curvature is available. X was added later and is very rare.