Freeze button for Arp in BioTek 2
-
- KVRAF
- 9913 posts since 15 Sep, 2005 from East Coast of the USA
The arp works normally in BioTek 2 but when I click the “freeze” button it won’t play any audio. I just wondered if there is a special way to use it, as I can’t figure out why it isn’t working.
-
Wolfram Franke Wolfram Franke https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=222340
- KVRist
- 79 posts since 25 Dec, 2009 from Germany
Hi Examigan,
"freeze" is supposed to act as a chord memory for the arp. Play a chord, hit freeze, and then play single notes to transpose that chord (of course broken up by the arp pattern). So, when you play Cmaj and hit freeze, playing an F should create an arp pattern in Fmaj.
Best wishes,
Wolfram
"freeze" is supposed to act as a chord memory for the arp. Play a chord, hit freeze, and then play single notes to transpose that chord (of course broken up by the arp pattern). So, when you play Cmaj and hit freeze, playing an F should create an arp pattern in Fmaj.
Best wishes,
Wolfram
-
- KVRAF
- Topic Starter
- 9913 posts since 15 Sep, 2005 from East Coast of the USA
Ok, but should it play the regular notes of the chord I am playing if freeze is on? I can't get it play any sound if freeze is on. I will try it again today, but it just didn't play the note whereas before when freeze was off, then the notes of the chord I played were audible. Will only the single notes you mention be audible, and not a chord?Wolfram Franke wrote:Hi Examigan,
"freeze" is supposed to act as a chord memory for the arp. Play a chord, hit freeze, and then play single notes to transpose that chord (of course broken up by the arp pattern). So, when you play Cmaj and hit freeze, playing an F should create an arp pattern in Fmaj.
Best wishes,
Wolfram
EDIT: I just tried it again, and now I see how it works.
Sorry for the bother, and thanks again Wolfram!