Multibands: Mute/Solo/Bypass available for automation ?
-
- KVRAF
- 3729 posts since 3 Nov, 2015
Mute/Solo/Bypass are not available for automation, can they otherwise be made available ?
-
- KVRAF
- Topic Starter
- 3729 posts since 3 Nov, 2015
Not sure what the 'top list' is, but I looked again at the small window where the list of params are shown, specially near the end, taking care to scroll very slowly, and I did not see a param for band 6 that would carry a name that points to mute/solo/bypass.
Usually with those parameters and Bitwig, for 99% of the plugins I use, when one parameter is activated by the user Bitwig makes it float very clearly at the top of the list. For instance here I moved the dry/wet parameter of band 1. However, activation mute/solo/bypass on any band does not make any parameter float up, which might be because there are none ?
Usually with those parameters and Bitwig, for 99% of the plugins I use, when one parameter is activated by the user Bitwig makes it float very clearly at the top of the list. For instance here I moved the dry/wet parameter of band 1. However, activation mute/solo/bypass on any band does not make any parameter float up, which might be because there are none ?
You do not have the required permissions to view the files attached to this post.
-
- KVRAF
- 10376 posts since 2 Sep, 2003 from Surrey, UK
There are parameters for Band Mute and Band Bypass (not Solo, though).
These are not immediately available for host automation; you need to assign them to Multiparameters first. And Band Gain, Limit (Split frequency) and Pan are also available:
These are not immediately available for host automation; you need to assign them to Multiparameters first. And Band Gain, Limit (Split frequency) and Pan are also available: