MuTools

mgiambro · Post by **mgiambro** » Thu Sep 06, 2018 5:44 pm

Help get MuLab get higher up - where it deserves to be!

https://www.strawpoll.me/16371302

runaudio · Post by **runaudio** » Thu Sep 06, 2018 8:33 pm

Done

mgiambro · Post by **mgiambro** » Fri Sep 07, 2018 8:54 pm

runaudio wrote:Done

Well done sir (or madam). The results of that poll do seem a bit skewed. I don't want to be mean, but how the hell is Tracktion Waveform so high up?? I had a play with it. I like the interface, but it was a complete (unpredictable) crash-fest for me. It just seemed to crash randomly. The more daws I try, the more I realise just how good MuLab is.

Watchful · Post by **Watchful** » Fri Sep 07, 2018 11:35 pm

mgiambro wrote:...how the hell is Tracktion Waveform so high up??

Because 100% of its users are on KVR, since its primary support channel is the dedicated forum here.

nenneb · Post by **nenneb** » Sat Sep 08, 2018 11:26 am

Done! I really do like MuLab

But please support the VSTi-Synth "MPS" with a new GUI-approach as well!
https://www.kvraudio.com/kvr-developer- ... dc18-15494

A single slider with a "musical name" adjusts a number of synth-parameters at once. I couldn't do that in MUX, therefore the talented german programmer and musician "Fullbucket" did it together with me ...

MuTools · Post by **MuTools** » Sat Sep 08, 2018 7:58 pm

Thanks for supporting MuLab, much appreciated!

MuTools · Post by **MuTools** » Sat Sep 08, 2018 8:00 pm

nenneb wrote:But please support the VSTi-Synth "MPS" with a new GUI-approach as well!
https://www.kvraudio.com/kvr-developer- ... dc18-15494

I'm not sure what you mean. Please elaborate.

A single slider with a "musical name" adjusts a number of synth-parameters at once. I couldn't do that in MUX

You can do that using a MUX meta-parameter.

Reincke · Post by **Reincke** » Sun Sep 09, 2018 4:44 pm

Done.

nenneb · Post by **nenneb** » Sun Sep 09, 2018 6:18 pm

mutools wrote:
nenneb wrote:But please support the VSTi-Synth "MPS" with a new GUI-approach as well!
https://www.kvraudio.com/kvr-developer- ... dc18-15494
I'm not sure what you mean. Please elaborate.

A single slider with a "musical name" adjusts a number of synth-parameters at once. I couldn't do that in MUX
You can do that using a MUX meta-parameter.

Well, please vote MPS for first place... thank you all in advance!

And yes, Jo, I know about meta-parameters and tried it with them. But in MPS we not only blend between different sounds, but manipulate the overtones as in the very center there is a blank sine (with all other sliders off). And I did not find a way to access the oscillators overtone sliders. Maybe it could have be done with a big number of oscillators, but then I wanted to add different effects, depending on the position of the x-y-pad and again found no way for doing that.
Well, I didn't say, that it is impossible to be done in MUX, but I could not. Also I did not make the programming of MPS ... I only mentioned wishes and FullBucket put them into code

Ambient Mechanics · Post by **Ambient Mechanics** » Mon Sep 10, 2018 6:38 pm

MuTools

KVR Audio

KVR DAW Poll