barber pole phaser pops and clicks

[tonycore]

hi - i followed the tutorial video for modulators, #2 (the normal modulator), using MFilter, to create the barber-pole phaser effect. everything seems to work, except that when i add more than one of the filters in (yes, i changed their phases by 90º each), i begin to get pops and clicks. these do not seem at all synchronized with the filters' movements, nor are they due to level issues, or cpu issues. i've checked that all the settings, modulators, transformation curves etc. are exactly as presented or very close. any ideas what this might be? it happens to whatever sound i choose to run through the phaser, also, so it doesn't seem program dependent.

also, as suggested, i have restarted my computer t ensure that DP is properly aware of the new plugins.

[tonycore]

additionally - this is in Digital Performer, v 9.5.2, about half the time after i stop the sequence from playing, or doable the plugin and then later re-enable it, it comes back not modulating properly at all, not following the modulators - i have to disable and re-enable a modulator itself (or some other parameter within the plugin) to get it to start working properly again.

[MeldaProduction]

Hi Tony, please post the actual settings, it's quite impossible to reply meaningfully like this.

[tonycore]

hi - so here's my preset, i assume that's what you need?

[MeldaProduction]

Ok, so it's because you used lots of harmonics - these created artificial bands and as you moved the main band, their number needed to change all the time creating phase discontinuities. So please just simple disable the Harmonics for all bands and it should be fine.

[tonycore]

thanks! still getting a handle on all the possibilities for tweaking your plugins...