I can't seem to automate the pitch wheel in Repro 5 (Logic Pro X) [Fixed]

[CircuitTree]

I have been trying to automate the pitch wheel (using Logic Pro X) and have not been able to. So far, I am automating the pitch by using the Master Tune parameter rather than automating the pitch wheel itself.

Whenever I try to select and automate the pitchweel, I see: PWheel Range- and PWheel Range+ which does not bend the pitch or do anything to the synth whenever I try to automate it.

Any help is appreciated.

[Captain]

I think this same issue was just discussed in another topic. I’m not at the computer right now, but AFAIR/AFAIK it’s like this: you don’t automate the pitch wheel (using host automation), you use good old MIDI, just like for the last 35 years or so. In Logic, if you set the automation mode of a track to Region, you can draw MIDI data just like any automation.

The PWheel Range+/- parameters set the pitch bend range, in other words, how much the wheel bends the pitch up and down when it’s moved.

[Urs]

Yep, was just discussed last week:

viewtopic.php?p=7250517#p7250517

- U

[CircuitTree]

Yep, was just discussed last week:

viewtopic.php?p=7250517#p7250517

- U

Ah ok, I did try searching it and when I came across that post, I thought it only applied to Hive... oops! Now I know. Thanks so much for the help.

[CircuitTree]

I think this same issue was just discussed in another topic. I’m not at the computer right now, but AFAIR/AFAIK it’s like this: you don’t automate the pitch wheel (using host automation), you use good old MIDI, just like for the last 35 years or so. In Logic, if you set the automation mode of a track to Region, you can draw MIDI data just like any automation.

The PWheel Range+/- parameters set the pitch bend range, in other words, how much the wheel bends the pitch up and down when it’s moved.

Thanks so much!!! I came across that thread but I thought it was just an issue with Hive when I first read it. I was able to make it work now : ] Thanks again!