u-he

Hanz Meyzer · Post by **Hanz Meyzer** » Tue Dec 25, 2018 12:13 am

Hi,

trying Zebrify and am pretty impressed how useful this is. Though could not figure out the following:

- How do I trigger/start an env only by an audio signal?
- Is there a workaround to have two signal followers?
- What is "essness"?

Thanks.

Howard · Post by **Howard** » Tue Dec 25, 2018 9:49 am

Re "essness": Quoting the Zebra2 manual, Zebrify chapter…

"ESS Sense
Ess frequency cutoff, from 4 to 8 kHz (‘esses’ are sibilants, high-frequency noises with little or no pitch content). The output of this section is the Essness modulation source."

Urs · Post by **Urs** » Tue Dec 25, 2018 11:53 am

Envelopes are only triggered by MIDI as of yet. I always wanted to add audio triggers, but as Zebrify was hardly talked about, it was overlooked. It seems that it became a lot more popular recently, so we might still go there at some point.

Hanz Meyzer · Post by **Hanz Meyzer** » Tue Dec 25, 2018 12:44 pm

I love it, so useful, but yes, IMHO could be much more useful easily.

Hanz Meyzer · Post by **Hanz Meyzer** » Tue Dec 25, 2018 1:57 pm

I wrote some suggestions for Zebrify here: viewtopic.php?p=7264570#p7264570

I will update it from time to time, in case you care.

u-he

KVR Audio

Zebrify 2.8.0 questions