If I arm a track ready for recording and the track has, say, a chorus effect on it, I used to be able to hear that effect BEFORE I hit play or record. So, I'm not sure what's happened but now I can only hear the effect once I hit record or play.
Live monitoring is on and as far as I know I haven't done anything.
Any ideas?
effects not heard until I press play
-
- KVRer
- Topic Starter
- 12 posts since 1 May, 2019
...but curiously, if I go to a previous project I can here the effect with the track armed but not playing as expected. So, perhaps it's some kind of project related corruption?
-
- KVRian
- 1302 posts since 3 May, 2005 from Victoria, BC
You have "Run Audio ENgine When Stopped" enabled from the options menu?
Do you have a plugin on the track with a lot of latency? Plugins will get disabled if their latency is higher than the value you have set for "Max Monitoring Latency"
Do you have a plugin on the track with a lot of latency? Plugins will get disabled if their latency is higher than the value you have set for "Max Monitoring Latency"
-
- KVRer
- Topic Starter
- 12 posts since 1 May, 2019
AHA! Found that option. It was on. However, I toggled it off and back on again and it's sorted it! I notice it had a shortcut key of Shift/E, so I'm assuming I must have done that by mistake.
Thanks Figbug I'll give you a bighug
Thanks Figbug I'll give you a bighug