MuTools

Linkage93 · Post by **Linkage93** » Thu Sep 19, 2019 8:17 pm

This is a basic question. How do I set up a mic to record on an audio track in mulab 8? My computer recognizes my microphone and I've used it for other things before. It's just that once I launch mulab I have no idea how to tell the audio track to record with my mic.

dakkra · Post by **dakkra** » Thu Sep 19, 2019 8:49 pm

Make sure you're using an ASIO driver for your audio. If your audio interface does not provide an ASIO driver, ASIO4ALL is a good way to virtualize an ASIO environment.

Once you've got an ASIO driver setup, add a new audio track and click on the arrow to open up the audio recording panel. There you can select mono/stereo recording and as of the beta (see the beta thread here) you can even see the waveform display for the incoming audio

jonljacobi · Post by **jonljacobi** » Fri Sep 20, 2019 3:08 am

Really? The wave finally shows up in real time? Cool. That's a nice step. Always a bit of a freak out not seeing that.

dakkra · Post by **dakkra** » Fri Sep 20, 2019 5:03 am

Yeah in the beta version, the audio input panel now shows a waveform. It's not in the arranger, but it is in the panel. Happy middle ground compromise, there was a whole thread about it: viewtopic.php?f=79&t=529142

EDIT: Link to beta thread: viewtopic.php?f=79&t=529868

MuTools

KVR Audio

I can't set up a mic to record