As a feature request - please do make the aftertouch panel work per channel when in mpe mode. It would not require any change to the GUI whatsoever. Standard channel aftertouch is exactly the same message in mpe, it's just received on every channel. So it would be confusing if you made a whole bunch of different aftertouch mod assignments for mpe (or used just a subset of the aftertouch mods) when it is in fact just standard channel aftertouch that is used for MPE. Thanks!jack [psychicmodulation] wrote: ↑Thu Oct 03, 2019 5:13 pmYes, when MPE is activated, aftetouch operates in a different way, so the controls for that are on it's own panel. But like I said, this is a standard implementation. I do plan to expand on it and possibly incorporate it into the main aftertouch panel, utilizing some, or all of those targets. But for now it's considered a different operation.Echoes in the Attic wrote: ↑Thu Oct 03, 2019 5:00 pmOh ok, that's really confusing because channel aftertouch is exactly what MPE uses (per channel). So now there are two channel aftertouch mod sources, the aftertouch panel (which becomes disabled I guess when MPE is activated?) and the single filter/amp aftertouch source. That's too bad. I was excited to use the aftertouch modulations per note. Ideally would be if there was another mod panel like the aftertouch panel for timbre as well but I understand that that's more work and GUI changes etc. I would have thought the aftertouch mods would work as is though.jack [psychicmodulation] wrote: ↑Thu Oct 03, 2019 4:54 pmThe Aftertouch panel is for standard channel aftertouch, this is not used in MPE mode. The MPE settings are accessed on the 'about' panel. Once MPE is activated, Filter(aftertouch) and Amp(cc74) are then controlled by MPE. Click the 'A:74' switch to reverse it so that Filter=cc74/Amp=Aftertouch. The knobs above this control the levels of these parameters.Echoes in the Attic wrote: ↑Thu Oct 03, 2019 4:35 pm I've just done some tests. I've got MPE turned on but the aftertouch modulation is still affecting things globally, not per note/channel.
The main Aftertouch panel on the interface is not part of MPE at this moment.
On a positive note - Pitch bend works well on mpe devices when in mono legato mode, which some instruments have trouble with. On fact the only other synths I’ve used that work properly in mono legato mode with mpe is cypher and equator (and bitwig instruments). So nice work getting that working.