I have setup a modulator to trigger white noise on a kick for example.
I am using the modulator to set the bandwidth on a lo pass filter.
All is working fine except the modulator envelope is slightly late.
Is there a way that anybody knows to make the modulator look ahead.
Spencer
Envelope Modulator and White Noise Late
-
- KVRist
- 298 posts since 26 May, 2016 from Byron Bay, Australia
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14339 posts since 15 Mar, 2008 from Czech republic
Simple - add delay to your input 
. The modulators follow the initial input, so if you do this, you'll basically make the modulator process signal earlier than the actual processing engine. You can then use ReportLatency module to make the DAW aware and compensate. Btw. also check the Settings / Smart interpolation, it and set it to Very high, it may also cause it, since modulators are granularized for performance reasons.
. The modulators follow the initial input, so if you do this, you'll basically make the modulator process signal earlier than the actual processing engine. You can then use ReportLatency module to make the DAW aware and compensate. Btw. also check the Settings / Smart interpolation, it and set it to Very high, it may also cause it, since modulators are granularized for performance reasons.
-
- KVRist
- Topic Starter
- 298 posts since 26 May, 2016 from Byron Bay, Australia
Thanks Vojtech
Just used Delay and Latency inside an MXXX1 Module and it works perfectly. I put it on one Knob. That means I can apply Look Ahead all over the place. You just have to remember to hit the Check Latency Button.
Spencer
Just used Delay and Latency inside an MXXX1 Module and it works perfectly. I put it on one Knob. That means I can apply Look Ahead all over the place. You just have to remember to hit the Check Latency Button.
Spencer