Osc never starts on +1 ( even when reset and phase is adjusted )

[gentleclockdivider]

When drawing an osc ( and reset is enabled ) , I can never get the osc to start at the verry beginning of + cycle
The basic downward saw never starts at +1 ( or rather +0.5 )
I tried different phase settings , however I never get the exact result as the waveform display ( using geomorph mode here )

[Urs]

Have turned Attack Smoothing off?

[gentleclockdivider]

Yes
This is the closest I can get , phase seting of zer o)

While this the zebra's osc view


While I actually want to have this

[Urs]

Is Sync on, too? - I think I made it so that it restarts at 75% of the phase, like it does on the Prophecy.

[gentleclockdivider]

Sync is not on because it inverts the polarity of the signal ( and it makes things even worse )

Here sync is on , OUCH...notice the anomalie ( sync and reset are on ) ?
Edit : just tried it with sync alone ( no actual sync amount ) and reset de-activated ...still no luck


Here sync alone with no sync amount

[gentleclockdivider]

75 % phase , still no luck ( sometimes the negative phase is abruptly cut off etcc..)
could you please upload an example and showcase that it can actually be done ( without artifacts ) ?

[Urs]

75 % phase , still no luck ( sometimes the negative phase is abruptly cut off etcc..)
could you please upload an example and showcase that it can actually be done ( without artifacts ) ?

Indeed seems to be impossible... not sure why. Must be because of the way PWM is implemented, I totally don't remember what I was thinking back then...

[gentleclockdivider]

O.K. fair enough

Will zebra 3 have regular V.A, osc's ?

Thanks for taking the time

[Urs]

Will zebra 3 have regular V.A, osc's ?

It'll have similar but improved oscillators. I suppose the phase knob will work as expected.