MeldaProduction

Svama · Post by **Svama** » Wed Dec 04, 2019 4:49 am

Why is it just a flat line inside the graph without movement, seems not correct to me!?

Tagirijus · Post by **Tagirijus** » Wed Dec 04, 2019 8:33 am

According to the manual it says:

PLR meter displays the true-peak-to-loudness ratio. It's similar to the crest meters, but based on the modern EBU loudness standard. It ranges from 0 to 20 and the higher the value, the less compressed (more dynamic) is the audio material. It tells you the difference between the maximum peak level and the Integrated loudness.

I just tested to overcompress my signal and refreshed/reset the PLR and the values changed. It seems to be an indicator for the overcall compression of the signal, if I understood it correct.

Svama · Post by **Svama** » Wed Dec 04, 2019 9:46 am

But the visualisation doesn’t change. It’s a flat line in the graph, but the plr value changes the whole time.

Svama · Post by **Svama** » Wed Dec 04, 2019 9:50 am

7C41772F-73DB-4C8E-AECB-0D8788744529.jpeg

Tagirijus · Post by **Tagirijus** » Wed Dec 04, 2019 9:58 am

Ok, I think I understand what you are talking about, now. I just tested it and I think the "problem" is that you have to zoom in on the vertical axis:

2019-12-04_10-56-02.png

I hope my screenshot shows that there are dynamic changes in the MLoudnessanalyzergraph as well? It's not as obvious as in Youlean Loudnessmeter, but you could zoom in more and change the speed of the graph so that it might become similar.

Svama · Post by **Svama** » Wed Dec 04, 2019 10:01 am

Okay, great. Thank you

MeldaProduction

KVR Audio

PLR visualisation in mloudnessanalyzer