Able to change wavetable sample based by custom gui control?

[alexang]

I'm creating a device and would like to swap out the sample of the wavetable based on a bank.

Is this possible?

[Chandlerhimself]

Yes, check out this video I made a few weeks ago. I hope it helps.

[alexang]

Thanks Chandler.

Your video doesn't show how to actually swap the sample though, it just shows after the fact.

Am I missing something obvious?

[Chandlerhimself]

The wavetable module doesn't use samples. It can create wavetables from samples, but it doesn't actually load samples. Just create a wavetable however you like and then use the banks mode.

[alexang]

Ah well not possible then. Was planning to create about 64 wavetables (each with say 128 wavetable cycles) that get chosen by dropdown.

I'll use Reaktor.

[Chandlerhimself]

I think you're missing something. It's easy to create a drop down selector and change wavetables in a device. I show how to do it in the video.

[alexang]

Ah. Thanks, got it.

You have to right click to access the banks on the oscillator. Missed that part.

[Chandlerhimself]

No problem. Its really useful. I've already created a pad device that lets you switch wavetables. Try it with other modules like the modal filter or even the EQ. There are a lot of cool things you can do with it.