Zebra geomorph , impossible to start at actual beginning of waveform

[gentleclockdivider]

I have tried different phase settings , but it is impossible for zebra to start at the actual beginning of the waveform ( reset is set to on , no soft attack )
Reason why this is important ( for me at last ) is the actual transient of the waveform

And here are some recording , as you can see the waveform almost always starts from the centre position of the (geomorph ) window

[gentleclockdivider]

Well , the solution seems to be to draw the transient in the middle of the window .
Imho this could be added to the manual , to avoid future confussion

[Urs]

I think there was a similar topic recently?

But yeah, that's one fo the quirks of Zebra2 which we would like to overcome with Zebra3.

[gentleclockdivider]

Great to hear

[Howard]

Well , the solution seems to be to draw the transient in the middle of the window .
Imho this could be added to the manual , to avoid future confussion

Appears to be correct with Phase set to the default 50.00 - thanks!