how is it possible to record with multiband convolution a impulse of a speaker ?

[magicmusic]

impulse.jpg

I try to create a impulse from my cabinet with mconvolution mb(i have connect mixer out to cabinet FX return, and signal is not distort). this do not work. maybe the dynamic is too few ?. see screenshot. with studio one IR Maker plugin i can create a impulse but this use sine tone.

maybe mconvolution impulse record can get better results ?

I noice that cabinet impulses sound better when the power amp distort and much input is given with IR maker.

But with mconvoltion i never get anything usefull. can the record code in the mconvolution not check if the received input is higher as -10 db. then it use this as start point. IR Maker have a latency measure. this send a impulse that sound same as impulse from multiband convolution and measure the latency in samples. this is need later for the sine sweep

[MeldaProduction]

For that you'd probably need a deconvolution tool, which I actually have , but it's secret and I'm not going to release it (at least for now), since it's a bit too geeky and haters are hating geeky stuff, so...

[magicmusic]

I think my impulses are correct with ir maker from studio one. and i find now a solution with mix 2 impulses that sound good and not dull or when i boost high harsh. I record another impulse with amp distortion and mix them. text with more explain is in video

[Faiky]

For that you'd probably need a deconvolution tool, which I actually have , but it's secret and I'm not going to release it (at least for now), since it's a bit too geeky and haters are hating geeky stuff, so...

Melda stuff is geeky stuff haha, and I love it!

[Hexspa]

i can haz sneeky geak vst?

[Dirtgrain]

Nothing gives me GAS more than secret plugins. Bring it.

[MeldaProduction]

Nothing gives me GAS more than secret plugins. Bring it.

You know, methane is actually more potent greenhouse gas than co2, so I'm going to save the world by not releasing it . Hehe no, it's really about the dev time I don't have to make this usable for "other" people

[magicmusic]

I have find the solution wy impulses sound not so good as real speakers. such a frequency response in the high freq is need. all cabinet sims cut higher frequency. now i try later with mcabinet MB and use the impulse only for high freq and for low freq i use existing impulse.

maybe mcabinetMB can change so it can load presets of mcabinet ?. I see in mcabinetMB no presets currently with 14.04

[timbit2006]

Nothing gives me GAS more than secret plugins. Bring it.

You know, methane is actually more potent greenhouse gas than co2, so I'm going to save the world by not releasing it . Hehe no, it's really about the dev time I don't have to make this usable for "other" people

So how many melda plugins do we have to buy to get you to hire an apprentice to finish these plugins?