Question about the Multisampler (Waveform 11 Pro)

[lastmessiah]

In most sample-playback devices, you can adjust the start and end points of a sample and then create a loop region on the waveform. You can do this with Waveform's Multisampler, but I've noticed a strange behavior when the end point of the sample tails the loop region. The sample will sustain normally in the loop region until the release period when it travels toward the end point - when it does this the level of the sample jumps up harshly and causes EXTREME clipping for the entire release period. I'm not sure if this is by design but I somehow doubt it. This only occurs when the loop region ends before the end point of the waveform, not when it loops from the absolute end to some other point. Has anyone else noticed this?