Is there a way to make an XY pad unipolar for any control, such as OSC FX? I know they are unipolar for filter cutoff, but I would like to have the whole of, say the x-axis, to control only the positive side of the OSC FX.
Maybe I am approaching things the wrong way and you can already do it.
Make XY pads unipolar for any control
-
- KVRian
- 713 posts since 25 Apr, 2005
-
- KVRAF
- 24442 posts since 7 Jan, 2009 from Croatia
Doesn't seem this is possible, XYs are bipolar by nature in Zebra. You can only make it so that one half of it affects the half of the Osc FX parameter, but the other half would do nothing.
-
- KVRian
- Topic Starter
- 713 posts since 25 Apr, 2005
Yeah that's what I guessed. Thanks for confirming it 
-
- KVRian
- 681 posts since 1 Jan, 2018
Well you could always set the nominal parameter value to the middle of the range you want to use. Set the Osc FX knob to +50% for example, then have your X axis add/subtract 50% from that.
-
- u-he
- 30215 posts since 8 Aug, 2002 from Berlin
Not in Zebra2, but in Hive (and also Uhbik2, Repro) we have the "unipolarize" transfer curve in the rectifier section...
-
- KVRian
- Topic Starter
- 713 posts since 25 Apr, 2005
Thanks very much for that. So simple yet it never entered my mind...what does that make me?cthonophonic wrote: Mon Apr 20, 2020 3:03 pm Well you could always set the nominal parameter value to the middle of the range you want to use. Set the Osc FX knob to +50% for example, then have your X axis add/subtract 50% from that.
