Hello,Everybody.
Sorry, Bad English.
I wrote the question again because I made a mistake in the place.
I'm newbie waveform.
How can I put multiple chords in a chord track?
Thanks!
About chord track
-
- KVRist
- 236 posts since 9 Feb, 2017
Hi,
you can make the chord track visible by the small eye in the top right corner.
you can add a chord by dragging and dropping a clip ( red tile) from the upper right into the chord track.
then you can add pattern in the properties panel.
then you can expand the chord clip on the chord track by clicking and dragging the right side of the clip:
dragging the arrow on the right will expand the clip. dragging the middle lines will expand the chord length.
you can set the key of the track in the master section to bottom right of the interface.
you can alter chords and inversions by using the arrows inside the chord clip itself too.
cheers
you can make the chord track visible by the small eye in the top right corner.
you can add a chord by dragging and dropping a clip ( red tile) from the upper right into the chord track.
then you can add pattern in the properties panel.
then you can expand the chord clip on the chord track by clicking and dragging the right side of the clip:
dragging the arrow on the right will expand the clip. dragging the middle lines will expand the chord length.
you can set the key of the track in the master section to bottom right of the interface.
you can alter chords and inversions by using the arrows inside the chord clip itself too.
cheers