MuTools

Doc Brown · Post by **Doc Brown** » Fri Jul 10, 2020 7:22 pm

How does Mulab compensate for hardware synths and midi tracks and audio tracks? Are the tracks separate or can the midi and audio both be combined to a single track.

Also, does mulab have a latency offset or loop back setting for hardware gear?

Thanks

MuTools · Post by **MuTools** » Fri Jul 10, 2020 8:27 pm

You can insert a Latency Generator module and set the latency to match the latency of the hardware gear, but switch off the Apply Delay. This will tell MuLab's APLC system to take that latency into account.

Doc Brown · Post by **Doc Brown** » Tue Jul 14, 2020 12:11 pm

Thank you for the reply. Is that information in the manual, I didn't see it anywhere?

MuTools · Post by **MuTools** » Tue Jul 14, 2020 12:16 pm

Yes: http://www.mutools.com/info/M8/docs/mux ... dules.html

docbot · Post by **docbot** » Tue Jul 21, 2020 6:43 am

Does APLC also take the latency of the Audio Interface into Account?

MuTools · Post by **MuTools** » Tue Jul 21, 2020 8:54 am

APLC is necessary to avoid differences in phase / timing between plugins that use a different processing latency. The audio output latency is common for all modules & plugins so no compensation is necessary.

MuTools

KVR Audio

Hardware synths