MSF: Pitch detection / auto pitch mapping when browsing samples?

[Annabanna]

Perhaps I've missed a way to do this.

I see how to detect incoming pitch for samples loaded into sampler module of MSF. The problem is that the most common scenario when I'm doing this is that I have dozens if not hundreds of similar samples, and am trying to quickly audition them.

When I press the forward/back arrows to load the next sample in the folder, it seems to skip the pitch detection. I can see how to fix this each time by opening up the advanced tab and clicking "detect pitch"

It would just be a LOT faster to work with if I could figure out how to always get it to automatically detect pitch and keyboard map accordingly as I quickly flip through folders full of samples.

Is there a setting somewhere for this?

[Annabanna]

Or perhaps an alternate way of live browsing vs clicking previous/next button.

Open to any workaround that might allow for auto-pitch detection/mapping during live browsing.

I know it seems like a small thing, but when auditioning thousands of sounds where each triggers once quickly and moves on to the next, that extra couple steps each time to manually tell it to scan each new sample ends up being 2/3 of the entire browsing time.

[MeldaProduction]

Hmmm, I'll check, not sure really, but I think it's intentional.