MeldaProduction

steve2KVR · Post by **steve2KVR** » Mon Aug 10, 2020 4:10 pm

There is "auto listen," and this would be a variation of that. I would like to be able to "solo" a band while I manipulate it's parameters and listen to the results. In this instance I am thinking of using this feature to find/change/etc "resonances" in the audio track.../sz~

Hexspa · Post by **Hexspa** » Mon Aug 10, 2020 5:08 pm

Not to hijack but being able to marquee select the bands from the band list would be great - to include marquee select for the Q, Frequency, or dynamics parameters.

Also, not to be picky, but does anyone else think the Q slider should be reversed?

Thanks.

steve2KVR · Post by **steve2KVR** » Mon Aug 10, 2020 5:36 pm

...not a hijack...I'm hoping for the "low hanging" fruit.../s~

Hexspa · Post by **Hexspa** » Mon Aug 10, 2020 6:19 pm

Not sure what you mean but marquee select could be used in conjunction with band solo.

Faiky · Post by **Faiky** » Thu Aug 13, 2020 6:03 pm

So maybe mixing with phase inverting to the original signal. If there're no changes, output is muted. If you change something, you can hear only the changings.

steve2KVR · Post by **steve2KVR** » Thu Aug 13, 2020 6:28 pm

This is a "workflow" request for me. Say I have a track that I want to remove some resonant frequencies. I would select a band/node, solo it, narrow the Q and raise the gain, sweep the frequency display until I was satisfied with the result, then invert...done and dusted. I know I can use "Auto Listen," but this flow would be much more direct, and often times the gain/vol. of the "Auto Listen" is way to low.../s~

MeldaProduction

KVR Audio

FR:MADEq solo a band