Hello,
I have some questions on unclear points...
- with the demo, when I select the audio interface (Fireface UFX) I have only Output 1+2 available in the Racks and Master, insteed of 20 outputs. Is it a limitation of the demo?
- is it possible to output a track/Rack to several different MIDI channels to external hardware synths at the same time?
- and a Rack to several devices and VST instruments at the same time? (in the 6 slots)
- is it possible to record and play SysEx in real time on a track? (Roland PG-1000 <-> D-50)
Thank you in advance
Some questions...
-
- KVRer
- 3 posts since 23 Oct, 2020
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
Please check if they're all enabled on MuLab menu -> Audio Setup -> Select Outputs.PhilippeDF wrote: Fri Oct 23, 2020 1:51 pm - with the demo, when I select the audio interface (Fireface UFX) I have only Output 1+2 available in the Racks and Master, insteed of 20 outputs. Is it a limitation of the demo?
Yes. Trick is to route the track/rack to a common point from where you can split the signal to several MIDI outputs. That's to be done in the modular area.- is it possible to output a track/Rack to several different MIDI channels to external hardware synths at the same time?
If you need more power for a single rack slot insert a MUX into that slot and within that MUX you have all modular power, including layering, splitting, etc.and a Rack to several devices and VST instruments at the same time? (in the 6 slots)
No, MuLab 8 does not support sysex, sorry.is it possible to record and play SysEx in real time on a track? (Roland PG-1000 <-> D-50)
-
- KVRer
- Topic Starter
- 3 posts since 23 Oct, 2020
Thank you for your quick answers.
I have already enabled the Fireface in Audio Setup without success. Only "Output 1+2" or "None" are available...
I have already enabled the Fireface in Audio Setup without success. Only "Output 1+2" or "None" are available...
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
-
- KVRer
- Topic Starter
- 3 posts since 23 Oct, 2020
Mac Pro 5.1 + Mojave
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
If you want to use the extra audio outputs you need to create respective "Project Audio Output" modules in the modular area = via the "Modular" button at the top. Double-click such audio output module to select the audio out pins of your audio device. These audio output modules will now be available as target outputs for the racks in that modular area / the rack desk.