MChannelMatrix VST always showing only two outputs

[mabian]

Hello,

I am using MChannelMatrix 14.10 (licensed) in REAPER 6, Windows x64.
Even though it's in a 4 channel track, and the plugin pins are shown as 4/8 in - 4 outs the plugin GUI always shows 2 input, 2 sidechain and 2 output channels. I have seen MChannelMatrix screenshots in your website showing 8 input, 8 sidechain and 8 output channels.

How can this be achieved? I tried both the VST2 and VST3 versions and it's the same.
Is there some setting I'm missing that allows to change the number of inputs and outputs?

Thanks,
Mario

[mabian]

Found it, I had to switch to Surround mode instead of L+R. Tricky to find

- Mario

[MeldaProduction]

Actually VST3 doesn't even have the switch and allows that always. You just need to provide enough inputs in Reaper

[mabian]

Actually VST3 doesn't even have the switch and allows that always. You just need to provide enough inputs in Reaper

This is strange, I'm confident I had 4 channels in the track and the VST3 was still showing 2.
Will check again.

Thanks for replying,
Mario