How to move automation tracks?

[DAlfaia]

Hi there! I wanted to move a clip that has an automation track 1 bar forward. I can just select the clip an nudge it 1 bar forward. The thing is, the automation track stays in the same place and I have to do a lot of adjustments to get it right again. Is there a way to move the automation track with the clip that it is controlling?

Thanks for the attention!

[boomt]

If you enable to padlock button on the bottom bar it will lock automation curves to clips and should do what you want.

[pough]

If your Control Panel is enlarged, it's the button between Loop and Snap.