Hey guyz,
i downloaded free demo pack and installed MAutoAlign. Now i am trying to align my kick and bass using spectral phase.
Everything works good if i use last Pro-Q on kick channel as natural phase signal or zero-latency. Instead if i use linear phase (that should be my favourite) i get a distortion in the high freq where i think kick's click should be.
I do not get any improvement increasing analysis time or ignoring freq range.
I attached a zip file with both examples.
What's wrong with my signal misinterpreted by MAutoAlign?
thanks in advance
N
MAutoAlign and input signal issue
-
- KVRist
- 370 posts since 26 Sep, 2014
MAutoAlign is to deal with phase issues that happen when the same instrument is recorded
using 2 mics. The phase issue happens when 2 mics are at different distances from the sound source.
Why are you trying to align kick and bass? Usually one ducks the bass to allow the kick to be heard better. And you would use a compressor, or maybe Spectral Dynamics for that.
Here's a video that shows what MAutoAlign is meant for:
www.meldaproduction.com/MAutoAlign
using 2 mics. The phase issue happens when 2 mics are at different distances from the sound source.
Why are you trying to align kick and bass? Usually one ducks the bass to allow the kick to be heard better. And you would use a compressor, or maybe Spectral Dynamics for that.
Here's a video that shows what MAutoAlign is meant for:
www.meldaproduction.com/MAutoAlign