MConvolutionMB: Panning IR's

[R13]

I have dual mono (L+R) IR's from a spring reverb device, and thought I could use the A and B slots to load them both in parallel to achieve a stereo signal. But I don't see any Pan control anywhere? I was assuming it would be in the 'Advanced' settings, where the IR start/end/widening/delay etc are.

Am I missing it, or is this not available?

The other feature I was looking for was the 'File' automation parameter that you get in MConvolutionEZ. With the host I use, this is very useful, as it exposes the IR name to the host, and allows you to change IR's in the same folder. I found this very useful, and was surprised it wasn't part of the paid version.

[goldglob]

Use 2 bands, Left IR in one, Right IR in the other.
Right click a band in the band editor up the top, set crossover to disabled (amounts to two bands in parallel).
Pan each band with its pan handle in the band editor.

Another thing is that if the two files are named appropriately, the plugin will automatically load both just by selecting one. (See the info about that by hovering mouse over the file directory and pressing F1).

Re 'file automation', I don't know.

[R13]

Thank you for this! I didn't know I could disable the bands' crossover and then use them to load individual IR's.
I also found you can add multiparameters for the IR 'File' (e.g. Band 1 > Tap A > File) to expose the IR name to the host.

Thanks for your help

[goldglob]

I also found you can add multiparameters for the IR 'File' (e.g. Band 1 > Tap A > File) to expose the IR name to the host.

Thanks for your help

And thanks for that info.