Suggestion - MRhythmizer Oscilloscope

[DaneJ]

Hello,

I really like MRhythmizer, although I find it very difficult to accurately manipulate the envelope of the Cutoff or Volume of the Audio, based off the Metering that is currently implemented into the design.

My suggestion would be to add an Oscilloscope to the current graph which would make it much easier to see the envelope of the incoming audio source, similar to Xfer's LFO tool does.

I tried to use the inputs/Outputs graph, but IMO it would be easier if one could see the I/O graph in the main MRhythmizer graph, or at least have a setting for this.



Thanks!

[MeldaProduction]

Hi, I'll keep that in todo list with low priority, way too many tasks now.

[DaneJ]

Sure thing! Thank you for taking this into consideration

[Starship Krupa]

Do you know about the other flavor of metering you can get by clicking on the tall button to the left of the bar graph meters?

[DaneJ]

Yes, however it is currently not possible to edit the envelope with an overlay on the graph, LFO tool does this, however I think that Melda has better interpolation, so this would be extra handy feature to have.

[GXG]

another place an Oscilloscope would be amazingly handy would be under the curve editor of the Waveshaper, ideally a pre and post version laid over each other, so you could see exactly what your curve was doing to the incoming audio waveform

[Lerian]

another place an Oscilloscope would be amazingly handy would be under the curve editor of the Waveshaper, ideally a pre and post version laid over each other, so you could see exactly what your curve was doing to the incoming audio waveform

+1