Hi Vojtech,
what does the automatic equalizer function in seperate mid and side function? Does it analyze the mid and side infos of the source file seperately?
I´d like to use the sound like function for the mid and side signal seperately, but it seems like this doesn´t work, cause it´s just analyzes the L+R signal of my source.
Is that correct, can it be changed?
Thanks and greets,
Marek
Automatic Equalizer question (MID/SIDE analyzes)
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14339 posts since 15 Mar, 2008 from Czech republic
Hi Marek,
it always analyzes a single curve, so "yes and no". If you just use M+S, then it will probably produce similar results to L+R. But you can equalize them separately, one EQ for M and one for S. I doubt it would make sense, but you can certainly try.
it always analyzes a single curve, so "yes and no". If you just use M+S, then it will probably produce similar results to L+R. But you can equalize them separately, one EQ for M and one for S. I doubt it would make sense, but you can certainly try.
