MeldaProduction

Svama · Post by **Svama** » Fri Apr 09, 2021 11:11 pm

Hi Vojetch,

is it poosible to snap the cross in the middle of a node when changing frquencies inside the graph? Would be much easier for removing recsonances for example. Most of the time the cross is somewhere at the node you´re moving, but not at the freuquency you´re really at in this moment.

MeldaProduction · Post by **MeldaProduction** » Sun Apr 11, 2021 6:55 pm

HI Svama, I'm afraid I'm totally confused. Could you try redescribing this?

Svama · Post by **Svama** » Sun Apr 11, 2021 7:02 pm

As you can see in the screenshot the cross for x and y is somewhere, but not in the middle. Would be great if I move the frequency node, that the cross of x and y would be straight in the middle of the node and not somewhere else.

Svama · Post by **Svama** » Sun Apr 11, 2021 7:04 pm

I mean the cross which goes over the whole frequency graph not the one for q or dynamic!
The one, which shows the frequency and the volume!

MeldaProduction · Post by **MeldaProduction** » Wed Apr 28, 2021 4:42 pm

Aaaha, understood! Makes sense. I'm not sure if it will be possible though, will try.

Svama · Post by **Svama** » Sat May 01, 2021 5:37 am

Thank you Vojtech, that was really fast. Small feature, which helps a lot.

Thanks and greets
Marek

MeldaProduction

KVR Audio

All equalizer cross snapping on node