How can i create DC in Melda?

[Mr D]

Hi folks,

Could anyone tell me a Melda plugin or MXXX module that will create DC?

I tried the LFO with a square wave, but unfortunately it won't go lower than 0.001 hz!

Any ideas? ............ Thanks!

[mcbpete]

Might be way off but try: MXXX Utility -> Math.
Under mode choose 'Add Constant', and in parameter you can enter the +ve/-ve value of the DC offset you wish to add (make sure to add just tiny values (Between -1 and 1) or your waveform will be in for a bad day !)

[steve2KVR]

...and mute your output until you're sure you got what you want...there is world of hurt out there for your headphones/speakers if your "experiment" goes badly...(experience)...hth.../s~

[Mr D]

Thanks, MATH did the trick!

This is for creating CV to go out to Eurorack gear, so it wouldn't go near my speakers!