Hi folks,
This is probably something super basic I'm missing, but is there a way to set the master play button in Super looper to reset the loops on stop so that they start playing from the beginning again when you restart?
I know there is a restart button, but that means an extra button/button press every time. I'm sure there might be a looping scenario where stopping and starting a loop mid flow is useful, but I'd imagine 90 percent of the time folks want to stop the loops, and then start the whole lot again from the beginning. Is there an option to link these functions that I'm missing?
Cheers folks.
Msuperlooper reset on stop/start
-
- KVRian
- 913 posts since 12 Sep, 2007
That's how it works on my system unless I'm not understanding something.
Your system starts from where it was stopped, like a pause?
Could be a preference somewhere, but I must be in the 10% that when I start loop1, it's the master and never stops. My flow is live looping though.
You might want to contact Melda support.
Good luck,
Dirk
Your system starts from where it was stopped, like a pause?
Could be a preference somewhere, but I must be in the 10% that when I start loop1, it's the master and never stops. My flow is live looping though.
You might want to contact Melda support.
Good luck,
Dirk
-
- KVRian
- 710 posts since 7 May, 2002 from Phoenix, Arizona, USA
Check a post I made here viewtopic.php?f=138&t=558854&p=7997874#p7997874
It can be done by using the MultiParameters. I labeled it as "Break Qtz"
It can be done by using the MultiParameters. I labeled it as "Break Qtz"