After upgrading MCCGenerator to v15 release candidate 2 I'm suddenly unable to save and load patches successfully. I use both the VST version in Kushview Element and the AU in Logic.
Simple test: Enable Mod 1 and change its waveform to sawtooth and save it. Then after reloading it goes back to Disabled and the default sign wave. Even trying to copy and paste to one of the copy buffers (A-H) causes the source to change. Is this happening only on my setup?
5kiMac, Catalina, 32 gig memory
Can't save patches in MCCGenerator rc2
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14339 posts since 15 Mar, 2008 from Czech republic
I just tried and the new release and it seems working fine. But there were problems with the storage here if I remember correctly, so please try the new rc, coming up today.
