MLoudnessAnalyzer wrong Integrated result
-
- KVRAF
- 10375 posts since 2 Sep, 2003 from Surrey, UK
Are you saying the the problem occurs only after 90 minutes analysing? Or at lesser times too?
(My measurements were done over 3-4 minutes only).
(My measurements were done over 3-4 minutes only).
-
- KVRAF
- 10375 posts since 2 Sep, 2003 from Surrey, UK
Hmm, and looking at your screenshots, several of the measurements differ by 0.8 to 0.9 dB
Last edited by DarkStar on Tue Jan 18, 2022 3:07 pm, edited 1 time in total.
-
- KVRAF
- 10375 posts since 2 Sep, 2003 from Surrey, UK
Some more info: I just ran a test over 40 minutes and the results were the same - no difference in the two meters
-
- KVRian
- 965 posts since 12 May, 2019
From what I understand, R-128 is the technical standard and +18 is just a way to display the meters.Held wrote: Tue Jan 18, 2022 7:08 am I don't know much about LUFS, but I can see that the LevelNorm shows EBU R-128 whereas MLoudnessAnalyzer is set to EBU+18. Could that account for the difference?
And if your request is time-critical, you should probably contact Melda directly via their form/email.
-
- KVRAF
- 10375 posts since 2 Sep, 2003 from Surrey, UK
Yes,
+18 means show a visible scale of -36 to +18 LU (for a target of -23, this is -49 to -5 LUFS)
+9 means show a visible scale of -18 to +9 LU (for a target of -23, this is -41 to -14 LUFS)
+18 means show a visible scale of -36 to +18 LU (for a target of -23, this is -49 to -5 LUFS)
+9 means show a visible scale of -18 to +9 LU (for a target of -23, this is -41 to -14 LUFS)
