Struggling with Studio One + MSuperLooper initial setup

[cpcrasher]

Hi All

It looks like MSuperLooper is exactly what I'm looking for. However, I'm struggling to make it work in Studio One. I "only" want to have 5 different instruments being detected and have each instrument loop on a separate output. However, i struggle with both doing of those things.

Inputs:
Reading the Documentation, I created a new Track, added MSuperLooper as a VST. Then i was able to select the side-chain options on the MSuperLooper VST and selected all instruments that I wanted to have as input. The result was, that all instruments would play through Input 2. If i select another input number on a MSuperLooper track it would not receive anything. How do I route in separate instruments into MSuperLooper so each respond to a different input Number?

Output:
In the Studio One Track where I added the MSuperLooper VST, I can only select one Output. If in MSuperLooper I select "Output 1" on any MSuperLooper Track this output is sent to the one I selected in the hosting StudioOne track. Selecting any other (Output 2, 3,4,5, etc) results in no sound being played. How do i route the outputs of MSuperLooper to separate Send/Bus tracks on Studio One?

image.png

[Weltenbauer]

Hi,
I have read your post. I have the same problems.
Du you have already found an solution?

Thank you,
Michael