Hello,
I have this very strange behaviour with the REAPER project attached: if I press a key so that the ARP starts triggering MIDI (project is not playing) and then I slooowly move the mod wheel, the mod wheel MIDI messages are received not smoothly (MOD wheel controls filter cutoff and here the messages are received only when the wheel is moved abruptly).
If I turn off BlueArp and turn on REAPER JS Midi Arpeggiator the mod wheel works perfectly, same disabling both arpeggiators, so I would tend to say it's not a hardware issue with the mod wheel...
Only Surge XT (1.1), Blue ARP (2.3.8 VST3), and native REAPER plugins are needed.
Could somebody kindly try and check if that happens as well?
Thanks,
Mario
Very strange CC input stepping [REAPER + BlueArp]
-
- KVRAF
- 3154 posts since 10 Jan, 2005
You do not have the required permissions to view the files attached to this post.
-
- KVRAF
- Topic Starter
- 3154 posts since 10 Jan, 2005
I have tried Zebralette instead of SurgeXT, same exact thing. I think something is going funky when Blue Arp is enabled...
- Mario
- Mario
-
- KVRAF
- Topic Starter
- 3154 posts since 10 Jan, 2005
Other information: Blue Arp VST2 does not cause the issue, only the VST3 version does!
- Mario
- Mario
-
- KVRAF
- 24405 posts since 7 Jan, 2009 from Croatia
https://forum.juce.com/t/vst3-midi-and- ... ders/52540
This is probably related (but not sure if BlueArp is JUCE based or not). At any rate, VST3 is entirely possible to have sample accurate MIDI, but depends how it's implemented in the plugin.
This is probably related (but not sure if BlueArp is JUCE based or not). At any rate, VST3 is entirely possible to have sample accurate MIDI, but depends how it's implemented in the plugin.
-
- KVRian
- 1447 posts since 17 Jul, 2007 from Riversland Valhalla
No it is not JUCE based, it's iPlug.EvilDragon wrote: Tue Aug 09, 2022 5:52 pm This is probably related (but not sure if BlueArp is JUCE based or not).
