I have a hydrasynth which has 3 option aftertouch off, mono or poly TX. i choose a preset in latest hive2 that has AT in the description and it responds to AT Mono TX setting only from the hydrasynth but does nothing if i set it to poly (AT) TX mode
What's the correct way to setup things at both ends for hydra synths poly after touch. there is some settings in the hydrasynth about MPE mode as well i switched those on and didn't work so I've just left it currently on Mono after touch TX and MPE mode off .
Im not sure what the daw midi input channels should be set to that Hive is on or if there's some setting hidden in hive i need to turn on.
It gets a bit confusing
Im using Bitwig which is suppose to work in mono, poly aftertouch mode and MPE modes as well.
Hive 2 polyaftertouch and a hydrasynth? only works in mono AT TX Mode from HS
-
- KVRer
- 9 posts since 5 Feb, 2007 from new zealand
-
Korg Supporter Korg Supporter https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=386399
- KVRAF
- 1886 posts since 4 Oct, 2016
Did you select pressure in Hive's modulation Matrix?
-
- KVRist
- 43 posts since 12 Mar, 2021
Check settings for the hydra in bitwig device inspector. I believe you have to enable mpe there.