Bazille -- adjust gate time in sequencer
-
- KVRian
- 927 posts since 13 Jan, 2013 from United States
Hi -- has anyone figured out if there is a way to shorten the gate time from the sequencer? Thanks.
-
- KVRAF
- 26963 posts since 3 Feb, 2005 from in the wilds
You can shorten the Gate of the Sequencer by modulating the Rotate knob with a short Square wave LFO. If the Seq is set to 16th steps, then make the LFO 16th's too. Since the Seq has 8 snapshots, you are shifting the Seq onto one of the blank snapshots.ontrackp wrote: Wed May 17, 2023 11:07 pm Hi -- has anyone figured out if there is a way to shorten the gate time from the sequencer? Thanks.
-
- KVRian
- Topic Starter
- 927 posts since 13 Jan, 2013 from United States
Ahhh… good idea, thanks
-
- KVRAF
- 26963 posts since 3 Feb, 2005 from in the wilds
You can also multiply the LFO Square with the Seq and use the LFO Phase to offset the Sequencer timing. Lots of fun to be had!
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
I just checked this trick - can't get it to work. Can you post an example patch, preferably the simplest possible?
-
- KVRAF
- 3729 posts since 3 Nov, 2015
On the subject of the Bazille sequencer, it could be nice to have an option to zoom on it, as is the case with the mapping generators. Sometimes minute step sequencer changes can make a good difference.