A-D Morph Zipper Noise
-
- KVRian
- 965 posts since 12 May, 2019
Hi, I'm learning MAutoDynamicEQ more deeply and was playing with the A-D Morpher and getting zipper-type noise when dragging the puck along the perimeter i.e. when sliding it on the edge of the interface. My source signal is pink noise and the A-D presets were each one single band 4 with default settings and a roughly 12dB boost or cut (A +12dB @ 100Hz, B -12dB @ 500Hz, etc.). I understand that zipper noise is a normal byproduct of level modulation but I'm pointing it out in case it's higher than Melda considers 'spec'. Thanks.
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14339 posts since 15 Mar, 2008 from Czech republic
Hey, this one is more complex since it basically alters all parameters and sets them up, things can happen. It's not really a good place for automation or anything.
-
- KVRian
- Topic Starter
- 965 posts since 12 May, 2019
I understand, thanks for your reply. This actually happens in the RME TotalMixFX faders too so I know it's a vexing problem. With A-D Morph, it's not just automation but also manual modulation. Anyway, I guess it's best to just be selective with this feature. Cheers.MeldaProduction wrote: Mon Jun 26, 2023 1:51 pm Hey, this one is more complex since it basically alters all parameters and sets them up, things can happen. It's not really a good place for automation or anything.