Using panning note info for actual panning in Bitwig and ZebraHZ

[Hanz Meyzer]

Hi,

since ZebraHZ does not support MPE, I guess note parameters are somehow limited. But is there a way to map the panning value of the Bitwig piano roll to the actual panning inside ZebraHZ?

There is MIDI CC#10 for panning, but I assume this works only per track and not per note...? If nothing helps, maybe I could use pressure for panning then?

Should I use the VST2 or the VST3 then?


Then in Hive CLAP, I mapped the pressure to the panning of OSC 1. But I can't find a way to get the full panning range to work, seems to be -50 to 50 instead -100 to 100 all the time.

Bildschirmfoto 2023-10-27 um 09.59.45.png

Bildschirmfoto 2023-10-27 um 09.59.40.png

Any tips and best practises here? Thanks for help!

[Howard]

... in Hive CLAP, I mapped the pressure to the panning of OSC 1. But I can't find a way to get the full panning range to work, seems to be -50 to 50 instead -100 to 100 all the time.

You could set the same modulation in the lower slot.

[Hanz Meyzer]

Thanks, that's a possible workaround. What about an additional modulator modifier "boost 2x" or so?