Uhbik vsts work fine, wait on vst3 for now

[glokraw]

I did read the vst3 warning readme, and in testing, only the vst3s crash, tried 5 of them, the vsts load/work fine
When the smoke clears this is what is in the terminal:

setNumInputs ( 8 );
setNumOutputs ( 8 );
allocateArrangement ( &plugInput, 8 );
allocateArrangement ( &plugOutput, 8 );
setNumInputs ( 8 );
setNumOutputs ( 8 );
allocateArrangement ( &plugInput, 8 );
allocateArrangement ( &plugOutput, 8 );
setNumInputs ( 8 );
setNumOutputs ( 8 );
allocateArrangement ( &plugInput, 8 );
allocateArrangement ( &plugOutput, 8 );
setNumInputs ( 8 );
setNumOutputs ( 8 );
allocateArrangement ( &plugInput, 8 );
allocateArrangement ( &plugOutput, 8 );
Segmentation fault

edit: in reaper, the channel re-assignments don't seem to take hold, and thus the 2/8 in+out label on the button above the Uhbik doesn't get relabeled when attempting to change the routing.

Uhbik-outs.jpg

Linux people have reported issues with other daws being perhaps confused with
processing the multi-channel options, and implementing the 'packaged' vst install.
setup, likely not knowing it's disabled. I kinda doubt they read the readme, but I'll suggest that way over yonder.
Cheers

[tasmaniandevil]

Please simply avoid using the VST3 version. After all, there is a reason why the warning exists in the installer.