I'm trying to integrate Waveform 13 Free with Bitfocus Companion. Has anyone tried this? Specifically, I created a Generic osc connection in Companion, I specified the ip address and port, and the connection was successful.
I created a button to send a message without an argument "/record".
Using oscd, I see the message is received as "OscMessage { addr: "/record", args: [] }".
I then turned off oscd and created a new Custom Control Surface in Waveform with OSC protocol.
I created a new custom control surface mapping with path "/record" mapped to function Transport->Record.
When I sent the message from Bitfocus Companion, the message indicator in Waveform flashes, but Waveform does not start recording. Has anyone else run into anything similar? Thanks!
Waveform 13 Free / Bitfocus Companion / OSC
-
- KVRian
- 1133 posts since 3 May, 2005 from Victoria, BC
Can you make an action that sends parameters and set the value to 1?
-
- KVRer
- Topic Starter
- 2 posts since 16 Apr, 2024
That fixed it! I struggled with that for hours and that's all it took.
Thank you so much FixBug!
Thank you so much FixBug!
You do not have the required permissions to view the files attached to this post.