MXXX MP Question

[dmbaer]

It's been a long time since I've tried to do serious development with MSF and even longer with MXXX. So, I've either forgotten something or there's been some changes.

I know for certain that I used to routinely be able to change the Min or Max value in an MP parameter entry from another MP (at least if it was in the first 8 entries). Now in MXXX I can't seem to be allowed to do that - either with auto-learn or with explicit definition (clicking the "+" button). The Min and Max targets are not there for the explicit approach and the Learn approach results in nothing happening.

Is there something I'm overlooking? Any ideas on what to try? I'm quite prepared for this to be embarrassingly obvious.

[al808]

Hi I think what you need to do is tick the box named "Assignable parameter ranges", in the right section of the parameter section of the multi-parameter pop up window.

[dmbaer]

Hi I think what you need to do is tick the box named "Assignable parameter ranges", in the right section of the parameter section of the multi-parameter pop up window.

Bingo! Thank you so much. I'm pretty sure this didn't use to be there and missed the memo that talked about it.