MXXX Limitations?

[ThatRedDot]

Hello,

I'm working on a set of effects in MXXX and run into some limitations in regards to assignment to multiparameters. In this particular case I'm working on an effect that relies on LP/HP filters from the Equalizer and I would like to assign the filter slope to a multiparameter (-12 to -60 dB) but no matter what I try, it seems I cannot map the slope to any parameter. Could someone please let me know how to go about this? I can't find anything in the documentation on how to do this, and the learn function won't do it for me either.

I would also like to know how to make 1 button react to another (with a enable/disable switch) so lets say I want to compensate button 2 with input of button 1 (for sake of simplicity lets say a gain control) that I can click a switch to ON, and after I do this and I put, say, +24 dB gain on control 1 it would put -24 dB on control 2. Surely something along those lines should be possible? Quite important for distortion filters.

Hopefully someone knows how to go about this, it would be much appreciated

Cheers

[Boone777]

I tried DynamicEQ the slope is assigned to multiparameter, it works for me.
Try moving the HP12 top left.
And yes you can link parameters it's in the settings when you double click on the parameter but I have not done this in a long time. You will find it on Youtube.

[ThatRedDot]

I tried DynamicEQ the slope is assigned to multiparameter, it works for me.
Try moving the HP12 top left.
And yes you can link parameters it's in the settings when you double click on the parameter but I have not done this in a long time. You will find it on Youtube.

Hey, thanks, but I don't mean the filter frequency. There are these buttons below it going from 1 to 10 which adjust the amount of dB/octave slope of the filter. I'm not able to connect those to a MP... Probably has to do that those are buttons and not a dial to adjust slope, not sure, but I really want to somehow connect those to a MP.

I'll check if I can find that link somewhere, wasn't able to earlier.

[Boone777]

I was refering to the slope not the frequencies. Maybe they can be link to switch or button. You can slide Lp12 or Hp12 box while parameter is on learn it will add it there.

[ThatRedDot]

I was refering to the slope not the frequencies. Maybe they can be link to switch or button. You can slide Lp12 or Hp12 box while parameter is on learn it will add it there.

Tried all that but it isn't working for Equalizer, but it seems to work just fine for BandPass filter, not sure why. So its sorted by using another filter option, though it would have been nice to use Equalizer for it since the other bands would be used as well, but I guess I can just run them in series and get around it.

I don't need to add DynamicEQ, functions aren't needed and will just use more resources than required. Need to keep it lean for this one

Thanks anyway for your help and suggestions, have a good one