Hi.
II want to send Osc 1 and 2 to the same filter (the filter is on "lane 1"). All I'm able to do is to send either of the 2 OSCs to the filter. Is it possible to send both?
I attached a screenshot.
Thanks
[attachment=0]Zebra.png[/attachment]
2 or more OSCs Into Same Filter
-
- KVRAF
- 6385 posts since 8 Jun, 2009
Does Osc2 need to be on a separate lane? If not just put both on the same lane. If it does, pop a mixer module above VCF1, rightclick on the mixer in the lane window and set the sidechain input to lane 2.
-
- KVRAF
- 1625 posts since 28 Jan, 2004
Click the Mixer tab on the OSC panel to access individual panning for each oscillator.
You can also route audio from one lane to another using the Mix module. Right click the Mix module to select the sources on the grid and mute the lane that you're not using.
You can also route audio from one lane to another using the Mix module. Right click the Mix module to select the sources on the grid and mute the lane that you're not using.
-
- KVRer
- Topic Starter
- 27 posts since 27 Mar, 2008
How did I miss the mixer tab? I'll try the mix module too.
I just came back to Zebra recently. One of the oldest synths out there, but still one of the best sounding.
Thanks.
I just came back to Zebra recently. One of the oldest synths out there, but still one of the best sounding.
Thanks.
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
I would like to recommend studying the user guides. Although I wrote them, I still have to check details now and again, as Zebra is such a complex beast!