Tracktion Software

bobaudio · Post by **bobaudio** » Fri Jan 07, 2005 5:56 am

I have end-to-end enabled on my kxproject ASIO input and everything is working as expected, except, during recording, I hear both the dry and the wet signal. (Wet from a vst reverb for example). I'd like to be able to play my guitar "wet" but I don't want to hear the dry signal while it is recording. Anyone else using the kxproject that might be able to point me in the right direction.

(Ps. I know this might be better suited to the kxproject forum, but you guys are nicer.)

bobaudio · Post by **bobaudio** » Fri Jan 07, 2005 6:00 am

Cool, I just figured it out. I disconnected the line to the xrouting module, but kept the one to the epilog. I guess I should have tried harder before asking. Thanks..

Ok, so, continue your t2 discussions, sorry for interupting...

morelia · Post by **morelia** » Fri Jan 07, 2005 6:06 am

No, please go on. I have the same problem but assumed there was nothing I could do about it as it happens in all audio hosts I use. It does suck but I would like to be able to monitor the signal passing through the effect without hearing the dry signal. Is there a way for an EWX24/96 user?

bobaudio · Post by **bobaudio** » Fri Jan 07, 2005 12:37 pm

Are you using the kxproject audio drivers? If not, I don't think I can help you. I can barely help myself. If you are using them, let me know and I'll send you a screenshot of my settings.

Warmonger · Post by **Warmonger** » Fri Jan 07, 2005 12:50 pm

bobaudio: Are you talking about the using the KX DSP (for your soundcards effects), or about wet/dry in Tracktion?

audiobot202 · Post by **audiobot202** » Fri Jan 07, 2005 1:59 pm

The KX drivers are a tad complex ! But yield good results.

bobaudio · Post by **bobaudio** » Fri Jan 07, 2005 8:24 pm

Warmonger wrote:bobaudio: Are you talking about the using the KX DSP (for your soundcards effects), or about wet/dry in Tracktion?

I am talking about the KX DSP which I now have working more-or-less as I'd like it to---using two ASIO inputs from my audigy breakout box, low latency, end-to-end with only the wet sound coming from tracktion.

I'm probably not using it to its full abilities (how to use the cards effects "effectively" eludes me).

If anyone needs a screenshot, let me know... and yes, I think the kxproject is a bit too complex....

morelia · Post by **morelia** » Sat Jan 08, 2005 7:54 am

bobaudio wrote:Are you using the kxproject audio drivers? If not, I don't think I can help you. I can barely help myself. If you are using them, let me know and I'll send you a screenshot of my settings.

No I am using the latest drivers for my Teratec EWX24/96. I have wondered if the ASIO for all drivers would work though. The problem you described initially is a real pain.

Tracktion Software

KVR Audio

Dry and Wet (need help)