Hello,
I found that in Nova 2.2.0 if I have a band active, then I "Band solo" it, and then disable it, the band becomes inactive and also disappears - it's not possible to click on its band or on-off button because they're greyed out; the easiest way I found to have it back is by double-clicking somewhere to re-enable it, but at that point its original frequency and gain settings are lost...
Is this known?
Nova VST3 2.2.0 n Windows - REAPER 7 x64.
Thanks,
Mario
Problem with Nova 2.2.0 and Band Solo
-
- KVRAF
- 3157 posts since 10 Jan, 2005
-
- KVRAF
- Topic Starter
- 3157 posts since 10 Jan, 2005
Adding: even after the band is re-enabled its on-off button stays "ghosted", not clickable.... 
- Mario
- Mario
-
- KVRian
- 1184 posts since 24 Feb, 2012
Oh good find! Fixing this asap.
Fabien from Tokyo Dawn Records
Check out my audio processors over at the Tokyo Dawn Labs!
Check out my audio processors over at the Tokyo Dawn Labs!
-
- KVRian
- 1184 posts since 24 Feb, 2012
Please download and install 2.2.0 again, the windows binaries have been updated already (mac follows in a few hours).
Fabien from Tokyo Dawn Records
Check out my audio processors over at the Tokyo Dawn Labs!
Check out my audio processors over at the Tokyo Dawn Labs!
-
- KVRAF
- Topic Starter
- 3157 posts since 10 Jan, 2005
I just tried the updated 2.2.0 Win version with Linux REAPER through Wine and Yabridge, seems fine!
The behavior now is even better than in 2.1.6: the on-off button there went disabled but was then re-enabled after exiting band solo. In the first 2.2.0 version the on-off button never came back (which is what I reported), in the updated one the on-off button always stays available.
I guess something got worse due to the band solo parametrization I see in the change log.
I'd like also to report a little thing in the Nova manual - a SPLIT band button is mentioned, but I think now it's been replaced by the WB button that seemingly works the opposite way (when enabled the Wideband controls apply, when disabled the band has its own controls); right?
Thank you very much for the ùberfast fix!
- Mario
The behavior now is even better than in 2.1.6: the on-off button there went disabled but was then re-enabled after exiting band solo. In the first 2.2.0 version the on-off button never came back (which is what I reported), in the updated one the on-off button always stays available.
I guess something got worse due to the band solo parametrization I see in the change log.
I'd like also to report a little thing in the Nova manual - a SPLIT band button is mentioned, but I think now it's been replaced by the WB button that seemingly works the opposite way (when enabled the Wideband controls apply, when disabled the band has its own controls); right?
Thank you very much for the ùberfast fix!
- Mario