How to get rid of dry signal in Spectral Delay

[Zathras_from_B5]

Is it possible to get rid of the dry signal in the Spectral Delay.
I would ´just like to hear the wet signal.

The adjustment of "Globals Dry/Wet 100%" does not do the trick. The dry signal is still there.
Only the Wet-Signal should be there
I am using Wavelab 12 for the plugin.

Any ideas?

[Held]

Setting Dry/Wet to 100% only gives you the wet signal.

Wavelab has it's own dry/wet control. Maybe it's coming from there.

Or maybe the wet signal isn't what you expected. Depending on how you setup the graphs at the bottom section, you can end up with something that sounds like the dry signal, even though it ran through the processing.

[Zathras_from_B5]

Ok, I check again. Thx and have a great day.